Pip after 2 weeks on cycle?

[Jimmygti]

Hi guys I started my first cycle 2 weeks ago all was going well and I was surprised at there being no pain or adverse affects whatsoever after all the research and reading I'd done I expected to run into something as a first time user. All of a sudden I'm experiencing muscle pain the day after injecting, it's localised to the glute I'm injecting into but the pain is fairly bad and even sitting down hurts, this has happened on the last two injections and I'm worried it will carry on as I can't train with that pain anyway.

I'm using Rip blend which is a mix of - testosterone, masteron and trenbelone and injecting ever 3 days as per the instructions, as well as 50mg is dianabol a day too.

Should I try halfing the dosage of the rip blend? I'm only using 1ml but wonder if the pain lessens at ½ml any help much appreciated.

I'm holding the vial until it's around body temp too, and injecting slowly basically everything is the same as when I started but now I have pain

 

[P0N]

I have to get this out of the way first. Your first cycle should be test only, so you can learn how your body reacts to different compounds. Starting with these 4, and tren especially, is pretty reckless. That said, are you not rotating injection sites? Ideally you would be best not to pin the same muscle group more than once every 14 days, but at a bare minimum like 7 days. If you keep pinning the same muscle group over and over, you are going to get increasing pain and build up a lot of scar tissue. Also use as small gauge a needle as possible. 25g works well is you heat the vials with a heating pad or similar first.

PCS P0N
PharmaComStore Rep
"taz10" for 10% bonus
PM for link to order

 

[Jimmygti]

Hi, thanks for the reply and advice. The only thing I've used before is dbol but on its own results were ok but limited. I went with this mix because it seemed to offer what I wanted without too many side effects it's also fairly low dosage compared to some stuff out there I believe. I am pinning the same muscle group every 6 days, I'm using the upper outter quadrant of either glute in rotation. I guess I should be injecting my quads and glutes in rotation instead.

I haven't had any reaction to this blend in 2 weeks so maybe it is just me using the same sights over and over. Im using blue 25g needles they are pretty good and I barely feel them go in. Just to add I'm showering before hand and using alcohol wipes on the injection site and on my hands too.

 

[P0N]

It sounds like you should probably try adding quads, or other large muscle group to the rotation then and seenif that helps a bit. Do expect a fair bit of PIP the first time you pin a new muscle group though (virgin muscle). It will lessen. With subsequent injections.

PCS P0N
PharmaComStore Rep
"taz10" for 10% bonus
PM for link to order

 

[DylanGemelli]

why would you be using tren on a first or second cycle man?