Particles floating in my compound

[Highspeedchase]

Found some particles in my tren a compound from osgear … is it safe to continue taking? there’s some black specs floating around maybe a bad filter ? Not too sure never seen anything floating around any other orders I’ve had @OSGear what do you think ?

 

[RickRock]

Id toss it. I would not inject anything that had dark particles floating in it

 

[Mobsterthemod]

It's nearly done ergo it's from how you pinned the stopper.

 

[stevesmi]

were they there before you pinned?

 

[2Thick]

Found some particles in my tren a compound from osgear … is it safe to continue taking? there’s some black specs floating around maybe a bad filter ? Not too sure never seen anything floating around any other orders I’ve had @OSGear what do you think ?

Worst comes to worst just throw it out and buy some new gear.

 

[Highspeedchase]

were they there before you pinned?

Honestly couldn’t say I don’t normally inspect the oils when they arrive but from now on I will be … couldn’t imagine how they would get there after a few uses though

 

[Mobsterthemod]

Honestly couldn’t say I don’t normally inspect the oils when they arrive but from now on I will be … couldn’t imagine how they would get there after a few uses though

I said above how

 

[Ulter]

Honestly couldn’t say I don’t normally inspect the oils when they arrive but from now on I will be … couldn’t imagine how they would get there after a few uses though

it can take one time for a piece of the rubber to get in the oil. I don't know what you're doing. You could be very aggressive when you're drawing.

 

[Mobsterthemod]

it can take one time for a piece of the rubber to get in the oil. I don't know what you're doing. You could be very aggressive when you're drawing.

This. Even this week I made a mistake pushing a pin down the side of the stopper

 

[CEO]

Honestly couldn’t say I don’t normally inspect the oils when they arrive but from now on I will be … couldn’t imagine how they would get there after a few uses though

Bros, it's possible that using a cheap rubber stopper so if that's the case you gotta be super careful when you're drawing.

 

[ROIDDERS]

Found some particles in my tren a compound from osgear … is it safe to continue taking? there’s some black specs floating around maybe a bad filter ? Not too sure never seen anything floating around any other orders I’ve had @OSGear what do you think ?

I wouldn't necessarily throw it away. Just draw up the oil without drawing up the rubber into a new vial and then you'll be good to go